18
Installation
Installation
Installation
Installation
Condition
Condition
Condition
Conditions for the installation location
s for the installation location
s for the installation location
s for the installation location
•
Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
-
Gap to the back approx. 5 cm and to the side
walls each approx. 10 cm;
-
Place the appliance so that the appliance door
can open without being impeded.
•
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter “Technical Data” or to the rating label
located in the interior or on the rear side of the
appliance.
•
Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
•
Avoid the installation:
Avoid the installation:
Avoid the installation:
Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.
Height adjustment of the door
Height adjustment of the door
Height adjustment of the door
Height adjustment of the door
Before adjusting the height of the door, rotate the
downward adjusting nut clockwise for 2 circles with a
wrench, and loosen the downward adjusting nut.
Rotate the upward adjusting nut to adjust the height,
and then tighten the downward adjusting nut coun-
terclockwise again.
1.
When the door of refrigerator is low:
Open the door, use the accompanying wrench to
rotate the upward adjusting nut counterclockwise,
to move it upward until it is parallel and level.
2.
When the door of refrigerator is high:
Open the door, use the accompanying wrench to
rotate the upward adjusting nut clockwise, to
move it downward, until it is parallel and level.
The total height can be adjusted to 5 mm!
The total height can be adjusted to 5 mm!
The total height can be adjusted to 5 mm!
The total height can be adjusted to 5 mm!
Electrical connection
Electrical connection
Electrical connection
Electrical connection
WARNING:
WARNING:
WARNING:
WARNING:
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric
electric
electric
electric
shock
shock
shock
shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
WARNING:
WARNING:
WARNING:
WARNING:
•
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION
CAUTION
CAUTION
CAUTION::::
In case of disconnection or power failure:
-
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
•
Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
