BOMANN GSPE 7413 TI, Instruction Manual

Page: 7 / 24

7
Fixing the decoration panel

Separate the supplied Velcro strips (A) and (B)
from each other.

Glue the Velcro strip (A) on the wooden panel (at
the top and bottom) and the felt strip (B) in the
same heights on the appliance door.

Align the panel and the appliance front against
each other and fix the panel on the appliance
door.

First remove the factory-mounted short screws
(4xS1) from the door inside.

Screw the supplied long screws (4xS2).
Adjusting of the door spring tension
After fixing the decoration panel, the door spring
tension must be adjusted accordingly.

Turn the adjusting screws as needed in the
clockwise or counterclockwise direction. The steel
cable tightens or loosens.

Check the door spring tension. If the door remains
fully open horizontally and can still be easily
closed, the tension is correct. Otherwise do the
adjusting again.
Connection to the water supply
Connect the water inlet hose as well as the water
drain hose properly. Follow the instructions that we
give you under "Water connection".
Installation to the power supply
Consider the instructions that we give you under
"Electrical connection".
Adjusting the feet
Place the appliance in its proper position and take
care that it is leveled solid and horizontal. Check this
with a spirit level.
The maximum adjust-
ment height of the feet
is 50 mm.

You can adjust the back foot by the adjusting
screw (a) at the center of the appliance plinth front
with an Allen key.

Adjust the front feet (b) with a screw-wrench until
the dishwasher is leveled.
Fixing the diswasher
Fix the appliance by tighten the screws from the ap-
pliance inside to the provided holes accordingly.
A. If the worktop made of wood, fasten the appliance
to the worktop.
B. If the worktop made of marble or granite, fasten
the appliance sideways with the housing unit. Put
the screw covers on.