BOMANN GSPE 7413 TI, Instruction Manual

Page: 6 / 24

6

Consider the necessary installation dimensions
(see “Installation steps”).

Take care of a solid and horizontal position of the
appliance. If the appliance is not horizontally lev-
eled, adjust the feet accordingly.

Power cord and water hoses may not kinked or
squashed.

Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors),
as metal parts would be susceptible to corro-
sion under such circumstances;
-
in rooms where the temperature could drop
below freezing. Do not expose the appliance
any weather;
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.).
Installation steps
Attach the condensation strip
Attach the strip under the wooden worktop to prevent
it from damages of ascending water vapor.

First clean and dry the concerned area of the
worktop thoroughly.

Remove the protective foil from the condensation
strip and stick it flush with the worktop edge.
Cabinet opening
Prepare the cabinet opening according the drawing.
Unit mm
If the appliance is installed at the corner of the cabi-
net, there must remain enough space to open the
appliance door.
1 Kitchen furniture
2 Dishwasher
3 Appliance door
Unit mm
Dimension and preparation of the decoration panel
Prepare the wooden decorative panel according to
the dimensional drawing:
Unit mm

Align the drilling template and mark the necessary
holes. Check this with a spirit level.

Drill holes of Ø 2 mm and 8 mm depth at the pre-
marked positions in the panel.