BOMANN GS 3184, Instruction Manual

Page: 31 / 36

31
C
C C
Clea
lea lea
lean the
n the n the
n the appliance
appliance appliance
appliance including
including including
including interior regularly:
interior regularly: interior regularly:
interior regularly:
•
Remove the appliance content and storage at a cool location.
•
Use warm water and a mild detergent for cleaning the appliance interior as well as the exterior.
•
After everything was thoroughly dried, you can restart the operation.
Troubleshooting
Troubleshooting Troubleshooting
Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist Before you contact an authorized specialist
Problem
Problem Problem
Problem Possible cause
Possible cause Possible cause
Possible cause Solution
Solution Solution
Solution
The appliance is
not working
properly or at all.
-
Is the unit not connected to mains power?
-
Is the temperature properly set?
-
Is the place unqualified?
-
Does the content prevent the appliance
door from closing properly?
-
Are the ventilation openings clear of ob-
struction?
-
Insert the plug properly in the contact socket.
Check the fuse.
-
Check the temperature setting.
-
Check the ambient temperature.
-
Check the appliance content.
-
Unblock the ventilation openings, install the
appliance freely.
Appliance cools
too much. Is the temperature set properly? Check the temperature setting.
The food is too
warm.
-
Is the temperature set properly?
-
Was the appliance door open for an ex-
tended period?
-
Was large quantity of food placed in the
appliance within the last 24 hours?
-
Is the appliance near a heat source?
-
Check the temperature setting.
-
Open the door only as long as necessary.
-
Turn the control panel to a colder setting tem-
porally.
-
Check the location (see “Installation”).
Loud noise dur-
ing operation. Does the appliance not stand vertical or
horizontal? Adjust the feet accordingly. Liquid flow sounds
in the cooling circuit are normal.
Water on the
bottom. Is the temperature set properly? Check the temperature setting.
The housing
sides are very
warm. The refrigeration cycle takes place in the foaming. The heat exchangers are installed in the
housing covered. The appliance cut the interior heat, which must be dissipated through the
housing areas.
Water on the
outer surface. On days of high humidity, condensation might occur on the outer surface of the appliance. This
is no malfunction; you may simply wipe the water off.
NOTE: NOTE: NOTE: NOTE:
If a problem still persists after following the steps above, contact your trader or an authorized technician.