BOMANN GS 195.1, Instruction Manual

Page: 16 / 44

16
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter “Cleaning and Maintenance”.
Appliance Equipment
Appliance overview
1 Temperature control
2 Freezing drawers /
compartment
3 Feet
Delivery scope
2x freezing drawer, 1x freezing flap, 1x ice-cube tray
Installation
Conditions for the installation location

Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
-
Gap to the back approx. 50～70 mm, to the
side walls and above the device each approx.
min. 100 mm;
-
Place the appliance so that the appliance door
can open without being impeded.

Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under "Technical
Data" and on the rating label located in the interior
or on the appliance rear.

Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.

Avoid the installation:
-
near heaters, next to a stove, direct sunlight or
any other heat sources;
-
at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.
Electrical connection
WARNING:

The installation to the mains supply must conform
to the local standards and regulations.

Improper connection may cause to an electric
shock!

Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.

The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.

Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.

Connect the mains cable to a properly installed
and earthed wall outlet.

If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.