BOMANN EHBC 7934, Instruction Manual

Page: 41 / 48

41

Lift the rack upwards out of the upper mounting
holes.

Replace the racks after cleaning and drying them
thoroughly.
Cleaning the glass panel
If necessary, clean the inside of the glass panes.

Open the oven door.

Press in the opposite plastic fasteners of the re-
taining stripe and remove the stripe forwards at
the same time.

Carefully remove the glass pane.

Replace the glass properly after cleaning and dry-
ing it thoroughly.

Press the retaining stripe firmly back into place.
Reversing the bulb
WARNING:

Make sure that the appliance is turned off from
the power supply (fuse).

Allow the lamp to cool down before replacing the
bulb. There is risk of burns!
NOTE:
Use the correct bulb, heat resistant up to 300°C:
Type G9 - 220-240 V~ - 15 W

Unscrew the lamp cover, clean it with a dry cloth.

Change the bulb.

Reattach the lamp cover, check the functionality.
Troubleshooting
Before you contact an authorized specialist
Problem Possible cause / Action
Unit does not
work
Check the power supply.
Oven lamp
does not
work
Bulb is defective, was inserted in-
correctly, is not securely seated in
the socket, see
“Reverse the
bulb”.
Strong
smoke deve-
lopment
Grease residues in the oven
chamber, switch off the oven, al-
low to cool before cleaning.
NOTE:
If a problem persists after following the steps above,
contact your distributor or an authorized technician.
Technical Data
Electrical connection…………………………...………..
Connection voltage: …………...380-415 V 3N~ 50 Hz
Rated power: ………..……………..…..…........8300 W
Rated current: ………………......………..……3 x 16 A
Protection class: ………………………...………I / IP20
Dimension H x W x D / Weight……...……..…………..
Worktop cutout: ……….………...……..56.0 x 49.0 cm
Hob net weight: …………….…..……………...…9.8 kg
Cabinet cutout: .................60.0 x 56.0 x min. 55.0 cm
Oven net weight: …………………………..……28.7 kg
Available accessories……………………………………
Telescopic runner set: …………..…Art. no. 8 979 060
………………………………………………
(
not supplied)