BOMANN DU 654 G, Instruction Manual

Page: 22 / 28

1 Power Power Power Power level: level: level: level:
The motor begins to run at low speed.
produce no or little steam, in order to
2 Power level: Power level: Power level: Power level:
The motor runs at moderate speed. This setting
3 Power level: Power level: Power level: Power level:
The motor runs at high speed. The setting is
tracted or filtered (e.g. when frying).
NOTE
NOTE NOTE
NOTE::::
If a lot of vapour is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
running if absolutely necessary, since otherwise unnecessary energy is consumed.
The appliance and the operation there
well as the filter. The extractor hood and
WARNING:
WARNING: WARNING:
WARNING:
•
Before cleaning or maintenance work, the device should always turn off and
switch off the fuse.
•
Allow the unit to cool down before
•
Do not uses steam cleaners for
electric shock!
electric shock! electric shock!
electric shock! Hot steam could dam
tion.
CAUTION CAUTION CAUTION CAUTION::::
•
Do not use a wire brush or other sharp, abrasive items.
•
Do not use any acidic or abrasive
•
To clean the surface of the housing, use a mild
•
The appliance can be used again after
•
If you use your extractor hood in recirculation mode, you must
(see “Replacing the activated carbon
Cleaning the
Cleaning the Cleaning the
Cleaning the alumin
alumin alumin
aluminum grease filter
um grease filter um grease filter
um grease filter
WARNING: Risk of fire!
WARNING: Risk of fire! WARNING: Risk of fire!
WARNING: Risk of fire!
Grease residues in the alumin
peratures. It is therefore important that the grease filter is regularly cleaned / r
placed.
22
low speed. This setting is suitable for cooking on a low flame
to circulate the air around the kitchen.
The motor runs at moderate speed. This setting is suitable for normal cooking.
The motor runs at high speed. The setting is suitable if large quantities of smoke and steam need to be
is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
running if absolutely necessary, since otherwise unnecessary energy is consumed.
Cleaning and Maintenance Cleaning and Maintenance Cleaning and Maintenance Cleaning and Maintenance
thereof are best maintained by regular cleaning of your
tractor hood and accessories should also be cleaned regularly for hygiene reasons.
Before cleaning or maintenance work, the device should always turn off and disconnect
fore cleaning.
cleaning the device; moisture could enter electrical
Hot steam could damage the plastic parts. The device must be dry before restarting oper
Do not use a wire brush or other sharp, abrasive items.
Do not use any acidic or abrasive cleaners.
housing, use a mild detergent and a soft cloth to prevent
The appliance can be used again after everything has dried properly.
tractor hood in recirculation mode, you must replace the activated
bon filter”).
Grease residues in the aluminum grease filter may ignite on exposure to high te
peratures. It is therefore important that the grease filter is regularly cleaned / r
flame and for dishes which
ke and steam need to be ex-
is produced, the fan should be left running for a few minutes after cooking. Only leave the fan
ing of your extractor hood as
accessories should also be cleaned regularly for hygiene reasons.
connect the mains plug or
electrical components. Risk of Risk of Risk of Risk of
e device must be dry before restarting opera-
vent scratching.
vated carbon filter regularly
um grease filter may ignite on exposure to high tem-
peratures. It is therefore important that the grease filter is regularly cleaned / re-