BOMANN 778051, Instruction Manual

Page: 23 / 32

23
3
Take the guide rail (a) out of the bracket (b) and
fasten the guide rail to the pre-marked position
using the screws (S) (possibly pre-drill the screw
holes).
4 Insert the cover (c) until it clicks in the guide (a).
5 Release the bracket (b) from the appliance door.
Open the appliance and furniture door completely
and bring them together. Slide the bracket (b) into
the guide rail (a) and fasten the bracket again with
the screws (S).
6 If an aligning of the furniture door is necessary,
use the slot spacing.
7 Insert the cover (d) until it clicks in the bracket (b).
8 Secure the appliance at the top and bottom of the
built-in cabinet with the screws (S).
9
Press the rubber seal (R) between the appliance
and the built-in furniture (side without hinge).
Startup / Operation
Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for about four hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter
“Cleaning and Maintenance”.
Starting the appliance

Connect the appliance to the power supply.

Operate the temperature control. See also the
section
"Settings".
Settings
Setting [ 0 ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1 – 7 ] regulate the different val-
ues of the internal temperature.
Setting 0: Off state
Power level 1 + 2 :
lowest level → warmest internal temperature
Temperature range approx. +4°C∼+10°C
Power level 3 + 4 :
medium level → optimal operating temperature
Temperature range approx. +3°C∼+7°C
Power level 5 + 6 + 7* :
highest level → coldest internal temperature
Temperature range approx. 0°C∼+6°C
*Beware of high setting because the maximum level
usually already means "freezing point".
The temperature of the freezer is automatically con-
trolled by the power level setting in the fridge.
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
During initial operation, adjust the lowest possible
temperature (= highest power level) first, until the
appliance has reached the desired operating tem-
perature. Afterwards it is recommended to turn the
control back to a medium setting; correcting the tem-
perature at a later point would then be easier.
NOTE:
In generally a low to medium power level works best
for an optimized food storage. A high power level
also increases the energy consumption.
Interior light
When opening the fridge door, the interior light will
turn on automatically.