Bomag BW 100 AD-5, Operating & Maintenance Instructions

Page: 28 / 212

We wish to make explicitly clear that we have
not tested or approved any parts or accesso-
ries not supplied by us.
The installation and/or use of such products
may have an adverse effect on the active
and/or passive safety.
3.3.4 Damage, defects, misuse of safety devices
Machines which are not safe to operate or in
traffic must be immediately taken out of service
and shall not be used, until these deficiencies
have been properly rectified.
Safety installations and switches must neither
be removed nor must they be made ineffective.
3.3.5 Roll Over Protective Structure (ROPS)
The frame of the machine must not be warped,
bent or cracked in the area of the ROPS fas-
tening.
The ROPS must not show any rust, damage,
hairline cracks or open fractures.
The real machine weight must never exceed
the testing weight for the ROPS.
No accessories may be welded or bolted on
and no additional holes must be drilled without
the consent of the manufacturer, since this will
impair the strength of the unit.
The ROPS must therefore also not be straight-
ened or repaired if it is damaged.
A defect ROPS must generally be replaced
with an original spare part in close coordination
with the manufacturer.
Concerning your safety – Fundamentals for safe operation
BW 100 AD-5 28