O P E R A T I O N
15
Front Panel Controls
Main Power Button
The main power button disconnects 12V power from the LD-250, the antenna,
and the GPS connector on the rear of the LD-250.
Main Power Indicator
The power indicator illuminates to indicate 12V power is present at the LD-250. If
the indicator does not light when the unit is turned on check your 12V power
source.
Strike Indicator
The Strike Indicator emits a short flash when a lightning strike is detected. If the
Strike Tone Button is pressed the detector also emits a short beep.
Noise Indicator
The Strike Indicator emits a short flash when a noise signal is detected. If the
Strike Tone Button is pressed and Noise Beeps have been turned on in software
the detector will also emits a short beep.
Strike/Noise Switch
When pushed in, the internal beeper will emit a short beep when a strike or noise
signal is detected. When pushed out, no sound will emit from the internal beeper.
Close/Severe Alarm Switch
When pushed in, the internal beeper will emit a long beep when a close strike or
severe strike rate alarm is triggered. When pushed out, no sound will emit from
the internal beeper.
Close Indicator
The Close Indicator emits a long flash when a strike is detected within the set
close strike range. If the Close/Severe Tone Button is pressed the detector will
also emit a long beep.
Severe Indicator
The Severe Indicator emits a long flash when the strikes per minute rate reaches
or exceeds the set strike rate. If the Close/Severe Tone Button is pressed the
detector will also emit a long beep.
