6}
Try starting the vehicle, most vehicles will immediately start. Some
vehicles may require the N02 to be connected for up to 30 seconds before
starting. If the vehicle does not start right away, wait 20-30 seconds and try
again. Do not attempt more than five (5) consecutive jump starts within a fifteen
(15) minute period. Allow the N02 to rest for fifteen (15) minutes before
attempting to jump start the vehicle again.
7}
Once you have started your vehicle, disconnect the battery clamps, and
remove the N02.
Low voltage batteries & manual override
The N02 is designed to jump start 12-volt lead-acid batteries down to 2-volts. If
your battery is below 2-volts, the boost LED will flash in red. This is an indication
that the N02 can not detect a battery. If you need to jump start a battery 2-volts
there is a Manual Override Feature, which allows you to force “on the jump start
function.
Caution on Manual Override Mode
Use this mode with extreme care. This mode is for 12-volt lead-acid batteries
only. Both the built-in anti-reverse protection and reverse polarity protection
features are disabled. Pay very close attention to the polarity of the battery
before using this mode. Do not allow the positive and negative battery clamps to
touch or connect to each other as the product will generate sparks. This mode
uses very high current {up to 1200 AMPS} that can cause sparks and high heat
if not used properly. If you are unsure about using this mode, do not attempt
and seek professional help.
-3-
CAUTION!
