P803 / 00.11.14
12
MAINTENANCE
Daily Maintenance
•
Check that the mandrel is suitable for the RIVKLE®.
•
Check that the crimping pressure of the tool is suitable for the setting of the designated RIVKLE® (see pressure
adjustments).
•
If the mandrel is damaged or if you have difficulty unscrewing the nut, you must change the mandrel
•
Check that the following processes "screwing- crimping- unscrewing" are activated by pressure on the spindle
and trigger, without any RIVKLE® in place.
•
Check the anvil adjustment. Verify that the RIVKLE® is firmly and squarely against the anvil.
•
Always hold the mandrel perpendicular to the work.
•
About every 300 RIVKLE®, the mandrel must be lubricated .
•
After use, protect the mandrel with a RIVKLE®
General Maintenance
IMPORTANT
The maintenance of the tools must be carried out by skilled technicians. The operator should not be involved
in maintenance or repair of the tool unless the operator is skilled in these types of operations.__
The air pressure supply must be switched off before every repair or maintenance operation.
After 500,000 cycles, the tool should be disassembled, and worn and damaged parts replaced.
The following repair kits are available for the P803 tool.
*Push-pull valve kit
2368 0300 202
*Trigger valve kit
2368 0300 203
*Regulator valve kit
2368 0300 205
*Unscrew check valve kit
2368 0300 206
*Complete repair kit (includes all of the above) 2368 0300 200
The repairs must be performed in a clean area. Special service tools may be required (available from your Bollhoff
supplier)
Adding Oil
•
Recommended oil type: Mobil DTE (ISO VG 68) Hydrolub H68 Condat or similar.
•
Switch off the compressed air pressure.
•
Take out the upper screw from the oil reservoir (18)
•
Check the oil level in the hole (18), and top-up the oil until full to the bottom of the thread.
•
Replace the screw (18) with the seal (19)
•
Reconnect the compressed air and check the crimping pressure after maintenance.
•
In case of an insufficient stroke, repeat the operation.
Summary of Contents for P803
Page 10: ...P803 00 11 14 10 ...
