Bolide BN-NVR/32NX, User Manual

Page: 23 / 80

18
4.2.1.3 Network
4.2.1.3.1 Network
Go to “Main Menu” → “Parameter” → “Network” to enter into the interface.
Select a kind of network connection (PPPOE, DHCP,Static) and set Port, then user may
remotely control the monitoring, recording, playback or backup of NVR through network.
Take DHCP as an example. In this mode, the router automatically assigns IP address
for NVR. After restarting NVR or DHCP server, the IP address obtained by NVR may be
different. As a result, user shall check IP address and port number for each remote access
of NVR. The operation procedure is as follows:
1. Select DHCP, click Save and refresh NVR. Input Client Port and HTTP Port (the two
values must not be the same).
2. Set obtained IP address of NVR and the mapping port. Refer to section4.2.4.2.
3. Remotely visit NVR by IP address
：
http://Public network IP: Web port number
（
such as 00080
）
http:// Intranet IP: Web port number
（
such as 00080
） （
Only available in the same LAN
）
For PPPoe, Static and DHCP, after setting IP address of NVR, the extranet port
shall be mapped on the router before visiting NVR through public network.
Note:
Save after setting to make effective. If there are multiple NVR in a LAN, make
sure their MAC addresses are different (Refer to System).