7
3.3
Maintenance Procedures
Annual maintenance works are carried out by service company employee and include:
1)
Visual checking of the MP conditions;
2)
Checking output voltage when the load is connected as per 1.2.2 – 1.2.3 of this manual and
performance of the external indicator.
3)
Verifying the MP is secured reliably and external installation wires and contact joints are in
proper conditions.
3.4
Checking Operability
Full inspecting of MP operability can be conducted only by the manufacturer or in special
laboratories.
1)
Turn the MP on as discussed in 2.3.1.
2)
Measure the output voltage of the MP. The output voltage value shall be within the range
indicated in 1.2.2.
3)
Ensure the HL1 indicator is healthy (see Appendix B for the layout).
The MP is considered to be operational if requirements 3.4-2), 3.4-3) have been met.
3.5
Technical Examination
Technical examination is not applicable for this equipment.
3.6
Preservation
Preservation is not applicable for this equipment.
4
Repair
4.1.
An equipment fault resulted from consumer’s not observing rules of mounting and operation
is not a reason for claims and warranty repair.
4.2.
Repair of faulty equipment is to be conducted by the manufacturer or in authorized repair cen-
ters. The product shall be sent for repair in compliance with Company Standard QMS 8.5.3-2015, which
can be found online at our website
https://bolid.ru/support/remont/
.
4.3.
An equipment fault resulted from consumer’s not observing rules of mounting and operation
is not a reason for claims and warranty repair.
4.4.
Claims shall be submitted to the following address:
NVP BOLID, #4 Pionerskaya Str., Korolyov, Moscow Region, 141070, Russia
Phone/fax: +7 (495) 775-71-55 (PBX) E-mail:
.
4.5.
In case of any issue related to use of the product, please contact the technical support:
+7 (495) 775-71-55 or e-mail
.
5
Storage
Storage in a transport container is permitted in unheated warehouses at ambient temperatures
minus 30 t50
°
С
and relative humidity up to 95 % at +35
°
С
.
ATTENTION!
The manufacturer accepts no claims unless a malfunction report is applied
Attention!
The equipment shall be submitted for repair being assembled and clean and along
with all the parts listed in the documentation.
Claims are accepted only if a reclamation report describing the failure is applied to
the submitted equipment.
