7
NOTE
NEVER PRY OUT GENERATOR WITH A LONG
HEAVY BAR OR TOOL AS THIS COULD RESULT
IN PREMATURE BEARING FAILURE.
7. Tighten the generator adjusting screw “A” and jam nut
and generator mounting screws “B”. Make sure all bolts are
securely tightened.
STOPPING THE ENGINE
1. If the engine has been operating under a heavy load and
is hot, do not stop engine suddenly. Allow it to idle for
approximately three to five minutes. This will reduce the
engine temperature more quickly and evenly than stopping
the engine suddenly.
2. Turn ignition switch off, put transmission lever in
“PARK” position, P.T.O. lever in “OFF” position and
remove key.
OPERATION
BEFORE DRIVING THE HUSKY, THE OPERATOR
SHOULD BE FAMILIAR WITH THE LOCATION AND
FUNCTIONS OF ALL CONTROLS. THE ENGINE
WILL START ONLY WHEN P.T.O. LEVER IS IN OFF
POSITION AND TRANSMISSION LEVER IN PARK OR
NEUTRAL.
Placing the transmission lever in PARK or NEUTRAL
position locks the travel pedal in its centered or neutral
position, to prevent use of the travel pedal when selector
lever is in PARK or NEUTRAL.
Depress foot brake (Figure 4, Reference 6) and place
transmission lever in DRIVE position. ALWAYS DEPRESS
FOOT
BRAKE
PEDAL
BEFORE
MOVING
TRANSMISSION LEVER INTO “NEUTRAL”, “PARK”
OR “DRIVE” POSITION TO AVOID CREEPING.
Release brake pedal, and slowly apply pressure to the travel
pedal with toe of right foot for forward motion, or if reverse
motion is desired, slowly apply pressure to travel pedal with
heel of right foot. (See Figure 6.)
The hydraulic lift lever can be manoeuvred while vehicle is
at rest or in motion. Lift lever to raise and push down to on
lever to lower attachments. When the lever is released, it
will automatically return to NEUTRAL position and hold,
except when in the FLOAT position. Push lift lever all the
way down to lock in FLOAT position. The FLOAT
position must be used when the operator wants the
attached implement to follow ground contours
independently. (See Figure 8.) Consult your attachment
manual for correct lift lever position.
Be sure attachment is completely hooked up before
using hydraulic lift. Damage could result. Move the
attachment through the complete range slowly to
make sure it does not bind or have interference. Make
necessary adjustment if required.
