BOJ 05203004, User Manual

Page: 5 / 44

English
- 5 -
Name Status Function Action
Button light
Blinking when
warming up
Wait for ready
Light steady Ready
Each button blinks circularly In energy saving mode
Light in used capsule container Light steady when handle is open
Check if the used capsule
container is full or not
Fill/refill water
There are two ways to fill the water tank: directly into the machine, by using for example a jug, or by removing the water tank:
• Filling without removing the tank:
• Raise the water tank lid.
• Fill the tank up to the “Max” mark with cold fresh water (the maximum capacity is 0.8 litre), or at least the “Min” mark.
• Low down the lid.
• Filling by removing the water tank:
• Hold the water grip at tilting angle as shown in direction 1 to remove the water tank from the machine.
• Fill the tank up to the “Max” mark with cold fresh water (the maximum capacity is 0.8 litre) or at least the “Min” mark.
• Slide the water tank slowly on water tank base. when the water tank outlet is inserted in the inlet receptacle. pushing firmly on the water
grip as shown in direction 2 to lock the water tank.
Flushing out the machine and internal piping/first use
• Fill water tank to maximum level .
• Plug in appliance to and turn it on.
• The lights on the control buttons are blinking. blue lights in used-capsule container is lighted in blue which goes off after
1 minute.
• Tips: you can check easier if the used container is full or not when the blue light is on.
• The indicator will blink in red for first use, meaning the internal circuit is empty- Please fill up the water and open the handle,
press any button to start pump. once water is detected entering the internal circuit. the red indicators becomes blue.
• The machine starts to heat up automatically when detected water in circuit with 3 buttons blinking.
• The lights on buttons become steady when the machine is heated up, heating up time is 40 seconds approximately.
• Press the lungo coffee button, before pressing the button. make sure that:
• The handle is closed without capsule inside.
• The water tank is full.
• The water tank is in place before brewing. Because there is hot cleaning water coming out during heating up beware
of hot water: danger of scalding!