boink Inmate QX7, Mounting Instructions

Page: 15 / 21

4. (a) Drill hole into the concrete with a carbide tipped masonry drill bit . Make sure
hole depth is 1”.
(b) Clean out concrete dust from hole using a wire brush, compressed air or a blow out
bulb.
(c) Drive anchor into the hole, flush with the surface of the concrete.
(d) Using the proper setting tool for the anchor, expand anchor by inserting the set-
ting tool into the anchor and set with several solid hammer blows. The anchor is set
properly when shoulder of setting tool is flushed with the top of anchor. To set anchor
below surface; drill hole deeper than anchor length. Thread bolt into anchor. Hammer
anchor into hole until bolt head is at a desired depth.
5. Fix the back-mount frame to the wall with (12) hex bolts 1/4” x 3/4”. Use the 7/16” wrench.
1/4” X 3/4 HEX
BOLT
PAGE 15 OF 21