6
Rev. 3
Instruction Manual - Pico Drill 100 (L)
01 Machine EC Conformity Declaration
in accordance with EC Machine Guideline 98/37/EC, Annex II A
We hereby declare that the model Manufacturer: Bohle AG
Machine type: Pico Drill 100, Pico Drill 100 L
in the supplied version meets the requirements of the following relevant
regulations:
EC Machine Guideline
(98/37/EC, Annex I)
Low Voltage Guideline
(73/23/EEC of the version 93/68/EEC)
EMC Guideline
(89/336/EWG of the version 93/68/EEC)
Applicable harmonized standards, especially EN 50 144, EN 55 014, EN 61 000,
IEC 60 745
Dr. Paul-Hermann Kroehs · Director, Torgau Plant · Bohle AG / NL Torgau ·
Gewerbering 16 · 04860 Torgau
02 Intended use
The Pico Drill 100 (L) is a portable, water-cooled drilling machine for drilling flat
glass, natural stone or similar materials by means of diamond drills.
It can be used for simple drilling jobs both on glass processing tables as well as
on tables of other machines.
03 Technical data
Electrical Con.:
230 V, 40-60 Hz, 1150 W
Dimensions (WxHxD) :
260 x 460 x 280 mm
Drill:
l = 75 with 1/2" Belgian thread
Drill diameter:
3 - 100 mm
Range of speed:
500 - 1700 rpm (infinitely adjustable)
Glass thickness:
3 - 20 mm
Forward feed:
manual
Noise emission:
depending on speed
Switch setting 1 - 80 dB(A)
Switch setting 6 - 92 dB(A)
Laser
Wave length:
650 nm
Output:
<1mW
Laser class:
Class 2
04 Safety Information
General safety instructions
Observe the enclosed safety information for electrical tools as well as the
supplementary safety and operating information for machines with PRCD
safety switches.
Safety information for the Pico Drill 100 machines
Do not touch the running drill spindle
Use only sharp drills.
Secure the glass sheet against slipping.
The machine is only suitable for use on horizontally lying glass sheets.
To prevent the drill from lifting up the machine, it is recommended to affix
the suction feet (picture A, 1) to the glass.
Wear ear protection!
To connect the machine to a central water supply, connect the 1/2" hose
which is included to an appropriate stop-cock of the water supply.
When
you are finished drilling, this valve is to be shut off!
The stop-cock at the machine is only used to dispense and shut off the
coolant supply during drilling with the Pico Drill.
When using the laser:
The optional laser corresponds to laser class 2.
Do not look into the laser beam.
The laser light reflects on glass and mirror surfaces. For
this reason, the reflection guard (picture A, 2) must be
installed if the laser is used.
A
Summary of Contents for BO 79.200 L
Page 1: ...Pico Drill BO 79 200 L BO 79 201 L ...
Page 19: ...19 Rev 3 ...
