Label
Meaning
Connection
RG
relay green
to turnout decoder, blue/green wire connection
RR
relay red
to turnout decoder, blue/red wire connection
5.3.2 Notes on Wiring
Note for the connections:
–
"B" has to be connected with the center stud terminal ("B") of the digital control unit.
–
"0" has to be connected with the rails terminal ("0") of the digital control unit.
The center studs of the track have to be isolated into three consecutive track sections. Note:
–
The first section, the transition section, has a length longer than the longest pickup shoe.
Connect the center studs of this section to "Ü#".
–
The middle section, the brake section, has a length greater than the longest braking distance of
all trains. Connect the center studs of this section to "B#".
–
The third section must be either a transition section or a stop section.
–
If it is a transition section, it has a length longer than the longest pickup shoe. Connect the
center studs of this section to "Ü#" like the first section.
–
If it is a stop section, it has a length so that every loco comes to a halt reliably. Connect the
center studs of this section to "SG", and connect "S*" with "B"
A stop section is recommended, if you cannot be sure that any loco will brake down to a stop with-
in the brake section. If all locos stop within the brake section, then the third section can be a trans-
ition section.
The brake module is switched between the two states “brake” and “proceed” using the control in-
puts "R*", "RR" and "RG". Connect these to a manually operated control box, or to a märklin digital
turnout decoder.
If the third track section is wired as a transition track, the relay contact terminals "S*", "SG" and
"SR" are available for free usage. They may be used, for example, to control a light signal. In the
proceed state, "S*" is connected with "SG"; in the brake state, "S*" is connected with "SR".
Graphical wiring diagrams can be found in a separate document.
6 Maintenance and Care
The product does not require maintenance. If cleaning is necessary, the product should only be
cleaned with a dry cloth or a brush to remove dust etc. Do not use aggressive cleaning agents or
chemical solutions.
bogobit Standard-Bremsmodul · 2016-08-01
Seite 5 / 7
