fore the brake section, and a stop section (or a transition track section alternatively) after the
brake section.
The Bogobit Standard-Bremsmodul has the following features:
1. The brake module can be connected in parallel to a turnout or a signal (with double
solenoid drive).
2. In the proceed state, full digital voltage is applied to all track sections. (no jerky drive on
the transition track).
3. The control inputs can be driven universally by AC or DC voltage of either polarity.
5 Connection and Operation
5.1 Handling
The product consists of sensitive electronic components. Improper handling may destroy them.
Prior to handling the board, please discharge yourself from electrostatic charge. To do this, touch a
metal object (earthed), e.g. a metal PC casing. Try to touch the board only at the edges and avoid
touching any electronic components or copper routes on the board.
5.2 Mounting
Mount the module properly to the model railway framework. The module has holes with 3 mm
diameter for mounting. Use of wood screws with 3 mm diameter and a flat pan head is recommen-
ded. Use spacers (little plastic tubes) between circuit board and mounting surface. Tighten the
screws carefully, so that the circuit board does not warp. Also consider the instructions related to
heat generation in chapter 3.3.
5.3 Electrical Connections
5.3.1 Wiring Terminals
The external connections of the brake module are labelled on the board and explained in the table
below:
Label
Meaning
Connection
0
0
to digital control station "0" / track rails
B
B
to digital control station "B" / track center studs
Ü#
transition track
to center studs of the isolated transition track section
B#
brake track
to center studs of the isolated brake track section
S*
switch contact common if stop section required: connect to "B"
SG
switch contact green
if stop section required: connect to center studs of stop section
SR
switch contact red
if stop section required: no connection
R*
relay common
to turnout decoder, yellow wire connection
bogobit Standard-Bremsmodul · 2016-08-01
Seite 4 / 7
