18
System Programming
System programming lets you set certain UTI3
1
2 options and tone features using the DTMF keys of a telephone.
All programming is accomplished through the Override jack on the UTI3
1
2.
To program the UTI3
1
2 system, follow these instructions:
1
. Place the PROGRAM/RUN switch to the PROGRAM position. The green LED
will illuminate.
2. Access the UTI3
1
2 override port (either use a single 2500-type telephone or
Test Set).
3. You will hear 3 beep tones indicating access to the programming mode.
4. Dial the Feature Code and any required input data for the option you wish to
program. See the
Feature Codes & Defaults
charts.
5. Press the [#] key to store the programming data. If you don’t dial the [#], then the data is not stored.A double
beep will sound to confirm the entry. Continue with the next Feature Code immediately after the confirming double
beep. If the information is not accepted, you will hear a busy tone. In this case, you must hang up, check the code and
the data, then re-access the system and try again.
6. Once you have finished all programming, you must first hang up the programming phone and then place the
Program/Run switch in the Run position.The green LED will go out.
Paging Zone Groups
To program a paging zone group, dial the zone group feature code followed by the
zone numbers to be included in the paging zone group and a # key. For example, to
program zones
1
through 3 to paging zone group
1
, dial *0
1
0
1
0203#.
To clear zones from a zone group, dial the feature code for that particular zone
group followed by the # key with no zone data. For example, to clear all zones from
zone group one, dial *0
1
#.
When programming paging zone groups, the unit uses the default access codes for
zones and paging zone groups (0
1
through
1
2 for zones and *0
1
through *24 for
paging zone groups) rather than any renumbered access codes using Flexible Dialing.
It is possible to program a zone that is not installed into a zone group.
All-Call Zone Group
By default, the All-Call zone group is set to all zones.To program the All-Call zone group, dial the All-Call zone group
feature code (*97) followed by the zone numbers to be included in the zone group. For example, to program
zone
1
, zone 2, and zone 9 to the All-Call zone group, dial *970
1
0209#.
To return the All-Call zone group to All-Call, dial the feature code followed by 00# (*9700#).
To disable All-Call, clear all zones from its zone group by dialing the feature code followed by the # key.
Example: *97#.
Auto Select Zone Group
By default, the Auto Select zone group is set to no zones. To program the Auto Select zone group, dial the Auto
Select zone group feature code (*96) followed by the zone numbers to be included in the zone group. For example,
to program zone
1
, zone 3, and zone
1
2 to the Auto Select zone group, dial *960
1
03
1
2#.
Auto Select is enabled by programming zones into its zone group. Remember, no individual zone or zone group
selection is permitted for paging when this feature is enabled.
To disable Auto Select, clear all zones from its zone group by dialing the feature code followed by the # key.
Example: *96#.
