M2(W) / M3(W) / M6W
10
SETTING SYSTEM
The setting system consists of a scale pointer, different connection rods and
outlet shutters.
SETTING POINTER,
Hydraulic / CALIBRATOR.
➊
&
➋
The connection rod of the setting pointer must
be mounted / adjusted in such a way, that the
shutters of the spreader are closed - when the
setting pointer is placed on the scale ciffer ”
0
”.
(approx. 0,5 mm. opening)
The adjustment is made on the connection rod.
➌
As standard the connection rod is mounted in position
(Ø10 mm.)
In case very large quantities being used on 28 - 42 metres' spread width, a +40% /
-40% connection rod
(Ø12 mm.)
can be used as option.
Same connection rod is used for very small quantities
(Ø8 mm.).
ADJUSTMENT SHUTTERS
The shutters in the adjustment system are factory set so
that the machine distributes the fertiliser symmetrically.
That means that the fertiliser is shared in equal quantities
to each side of the machine.
The adjustment shutters must be adjusted so that the
shutters close exactly in the middle of the V-mark of
the bottom plate
.
Normally you should not adjust the 4 connection rods
connecting the adjustment axle of the machine and the
shutters of the machine. These connection rods should
only be adjusted in case the system has been
dismantled and therefore misadjusted.
The setting is of great importance for the symmetry of the spread pattern
.
Be aware that the adjustment shutters do not open equally in comparison to the V-
mark. This assymmetric function ensures automatic adjustment of the feed point
for precise spreading.
➊
➌
➋