20
XLT TS Series Service Manual
Dart MD10P Controller Programming Procedure
1)
Move the J1 program enable jumper to ON so that the configuration parameter
settings can be changed. When the J1 jumper is OFF the programming
features are locked out to the front panel user. The Jumper J1 is located under
the dust cover on the back end of the upper board.
2)
Put the control in program mode; hold the enter button until you see ( P 0 ).
3)
Hold the up arrow until the display reads ( P 10 ). Push the enter button once;
push the up arrow key until you reach ( 2 ). This puts the controller in time
mode. Push the enter button again.
4)
Hold the up arrow key until the display reads ( P 20 ). Push the enter button
once; push the up arrow key until you reach ( 2:40 ). This sets the minimum
display to 240 seconds (6 minutes). Push the enter button again.
5)
Push the up arrow key once the display should read ( P 21 ). Push the enter
button once; push the down arrow key until you reach ( 6:00 ). This sets the
maximum display to 600 seconds (10 minutes). Push the enter button again.
6)
Push the up arrow key once the display should read ( P 30 ). Push the enter
button once; push the down arrow to the appropriate time. This is the signal
input display reference time (at parameter 31 RPM). Push the enter button
again. Note that the distances below are the length through the bake chamber.
32" oven:
64 sec
40" oven
79 sec
55" oven
109 sec
70" oven
138 sec
7)
Push the up arrow key once the display should read ( P 31 ). Push the enter
button once; push the up arrow to the appropriate value. For Dayton gear-
motors use 2980 and for Baldor use 3094. This is the RPM of the encoder (at
parameter 30 time) for particular gear-motor/pickup combinations. Push the
enter button again.
8)
Push the up arrow key once the display should read ( P 32 ). Push the enter
button once; make sure the display shows ( 1 ). This is the pickup pulse per
revolution value. Push the enter button again.
9)
Hold the down arrow key until the display reads ( P 0 ). Push the enter button;
this will put you in run mode.
10)
The display should read ( 4:00 ); pan check the belt to make sure that you are
programmed correctly. The belt time is measured by starting when the
leading edge of a pan just starts to enter the bake chamber and stopping when
the leading edge of the pan just begins to exit the bake chamber.
11)
Once you are programmed correctly, move the program enable jumper J1 to
OFF so that these settings cannot be changed.
To reset all values to factory defaults, make sure that the Programming jumper is
set to ON (see step 1 above), and change the value of parameter 95 to 5, or press and
hold both enter and down buttons for 3 seconds while applying power to the unit.
