Operation
Turning extraction unit On
There are 2 stages to powering up your iQ extraction unit.
Firstly the main isolation switch must be switched to the
“
On
” position (Refer to
section
1
for switch location) by
depressing the Green side / (I) of the switch.
This will place the extraction unit in Standby mode,
indicated by the front panel power button glowing Red.
If the AD 500 iQ has a powder coated finish then the top
side of the switch should be depressed to power the unit.
To start the extraction unit press the front panel power
button (refer to section
1
for switch location) the button will
change from Red to Green indicating the extraction unit is
now fully On.
It is recommended that the rear isolation switch is left in the
On position and the front standby switch is used to toggle
the extractor On / Off.
Changing the display units
The Airflow and temperature readings can be displayed in 2
ways.
1.
Temperature displayed as
o
C
Airflow displayed as m
3
/h
OR
2.
Temperature displayed as
o
F
Airflow displayed as CFM
The display
value can be changed by pressing the “Enter”
button once.
5
01
Summary of Contents for AD500 iQ
Page 1: ...AD500 iQ V3 AUG 17 ...
