Page 7 of 13
5.2.4.3
Press Set key again to toggle between
adjusting set temperature and time
remaining.
5.2.4.4
Once all program steps are entered, pressing
Start/Stop/Reset will begin the program.
Pressing Start/Stop/Reset again will pause the
program. Pressing and holding
Start/Stop/Reset will reset the program to S1.
5.2.4.5
Temperatures can be adjusted from ambient
or 18°C (whichever is greater) to 75°C.
5.2.4.5.1
S2 and S3 can be turned off in the
program by adjusting the
temperature value down to the
value below 18.0°C, which will
display the word “OFF”.
5.2.4.6
Times can be adjusted from 000:01 to 999:59
(mmm:ss).
5.2.4.6.1
S2 and S3 can be set to hold
indefinitely in the program by
adjusting the time value down to the
value below 000:01, which will
display the word “HOLD”.
5.2.4.7
Upon completion of all steps, unit will beep
and flash time as 000:00. Temperature will
remain at last set temp. Holding
Start/Stop/Reset resets the cycle and shows S1
with its time and temperature.
6.0 Calibration
6.1 Turn the unit off and allow the interior surfaces to reach
ambient temperature. Place a certified reference
thermometer in the center of the tray. Ensure the
thermometer is not touching any parts of the tray.
Boekel calibration kit part number 240550 can be used
to assist in the setup.
