Bodyworx JX125, User Manual

Page: 11 / 25

10
7. MAINTENANCE
1. If the belt tends to move off the center, stop the treadmill.
Take the Hex Wrench and adjust the Hex Screw in the Rear
End Cap. For example, if the running belt is moving towards
the left side, tighten the left Hex Screw about 1/4
turn(clockwise); if the running belt is moving towards the
right side, tighten the right Hex Screw about 1/4
turn(clockwise); Turn on the treadmill after it has been
adjusted. If you find that the belt has not moved to the proper
un ion.
c
(Ps.
end-users use and the
position, please repeat the steps above. Don’t use the treadmill
til the running belt returns to the center posit
(Ps.1. This action is very important, if the belt is not in the
enter, be sure to follow above steps.)
2. The position of running belt might not stay precisely in
the center with slightly towards the left and right sides,
and the situation varies with how
weight of end-users. No need to adjust the belt if it doesn’t
rub against the parts aside.)
d
e screw to the original set.
(Ps. When the belt is sliding, please follow the above method
lubricate the running belt. )
K
2. Depending on the usage of the product, please apply
SILICON on the board according to the below chart. Use
the Hex Wrench to unscrew the bolt inside the Rear Roller.
Then pull the belt up and daub some SILICON to the center
of the board. After that, adjust the belt to the center of the
deck, followed by tightening th
to
GS/LBS Speed Interval
6KM/hr
below
1 year
6~12KM/hr
6 months
KGS
1 2KM/hr
above 3 months
4mile/hr
below
1 year
4~8mile/hr
6 months
LBS
8mile/hr
above
3 months