XRG5300
Page
7
Assembly STEP 1
Remove the Pop Pin
(#12)
that is pre-assembled through
the upper hole of the Shroud Frame
(#01)
. Then, open the
frames and insert the Pop Pin
(#12)
into the middle hole
located on the Shroud Frame
(#01)
and small cylinder on
the Main Frame
(#02)
until it passes through and clicks into
place.
For your safety, this Pop Pin
(#12)
MUST remain inserted
whenever the unit is in use OR if it is left unfolded and/or
unattended as shwon in Figure1. After you complete proper
assembly, you will be able to fold the unit for storage.
Hardware Required
Figure 1
Figure 2
FOLDING INSTRUCTIONS
(to store the unit):
To fold your unit simply remove the Pop-pin
(#12)
from
the upper hole on the Shroud Frame
(#01)
, fold the unit
and then insert Pop-pin
(#12)
into the Lower Hole of the
Shroud Frame
(#01)
until pass through, ensuring the
Pop-pin
(#12)
locks into place as shown in Figure 2.
Note:
Folding your unit is intended to allow you to store it
when not in use.
#12 Pop-pin
[1 piece]
Pre-assembled
Upper hole
(for storage)
Lower hole
(for riding)
