XRG5300
Page
9
Assembly STEP 3
Remove the Washers
(#18)
and Nylon Nuts
(#17)
that are
pre-assembled on the Seat Cushion
(#19)
, and set them aside
for now.
Attach the Seat Cushion
(#19)
to the Seat Cushion Tube
(#03)
using a total of three Washers
(#18)
and three Nylon Nuts
(#17)
that were previously removed and set aside. Slide the Seat
Cushion Tube
(#03)
into the Shroud Frame
(#01)
with the holes
on the Seat Cushion Tube
(#03)
facing downward to allow for
alignment with the hole on the Shroud Frame
(#01)
as
illustrated below.
Next, screw the Knob Bolt
(#11)
through the hole on the Shroud
Frame
(#01)
and through the hole on the Seat Cushion Tube
(#03).
Adjust the setting that best accommodates your height
and and always ensure the Knob Bolt
(#11)
is securely engaged
before riding
Hardware Required
#17 Nylon Nut (M8)
[3 pieces]
#18 Washer (M8)
[3 pieces]
WARNING!
Do not remove the Seat Cushion
(#19)
for any reason after you
have installed it.
Exercising on this unit without the
Seat Cushion (
#19)
can result in
SERIOUS INJURY.
Ensure the seat is locked in place
by tightening the knob prior to
use.
#11 Knob Bolt
[1 piece]
