13
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
2A.
Attach Center Frame
(D)
to Lower Crossmember
(A)
using:
2 - (#1) M12x80mm Hex Head Bolt
4 - (#5) M12 Flat Washer
2 - (#8) M12 Nylon Lock Nut
1 - (K) Bracket
2B.
Attach Back Pad Frame
(E)
to Upper Crossmember
(C)
using:
2 - (#1) M12x80mm Hex Head Bolt
4 - (#5) M12 Flat Washer
2 - (#8) M12 Nylon Lock Nut
1 - (K) Bracket
2C.
Attach Back Pad Frame
(E)
to Center Frame
(D)
using:
2 - (#1) M12x80mm Hex Head Bolt
4 - (#5) M12 Flat Washer
2 - (#8) M12 Nylon Lock Nut
1 - (J) Bracket
Summary of Contents for SOIB250
