11
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A.
Attach Uprights
(B)
to Lower Crossmember
(A)
using:
4 - (#1) M12x80mm Hex Head Bolt
8 - (#5) M12 Flat Washer
4 - (#8) M12 Nylon Lock Nut
2 - (H) Bracket
1B.
Attach Uprights
(B)
to Upper Crossmember
(C)
using:
4 - (#1) M12x80mm Hex Head Bolt
8 - (#5) M12 Flat Washer
4 - (#8) M12 Nylon Lock Nut
2 - (H) Bracket
Summary of Contents for SOIB250
