12
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
and after STEP 2D. Some components may be pre-assembled. Nylon lock nuts will not
fully screw onto bolts, they must be wrench tighten to fully go on.
2A.
Attach Top Frame
(F)
to Base Frame
(A)
using:
2 - (#2) M10x20mm Button Head Cap Screw
2 - (#8) M10 Flat Washer
2 - (#16) ø25xø18x20mm Bushing
1 - (#22) ø18x132mm Shaft
2B.
Attach one end of the Gas Spring
(#20)
to Base Frame
(A)
using:
1 - (#4) M8x45mm Hex Head Bolt
2 - (#9) M8 Flat Washer
1 - (#12) M8 Nylon Lock Nut
2 - (#18) ø8.5xø12x7mm Spacer
2C.
Attach another end of Gas Spring
(#20)
to Top Frame
(F)
using:
1 - (#4) M8x45mm Hex Head Bolt
2 - (#9) M8 Flat Washer
1 - (#12) M8 Nylon Lock Nut
2 - (#18) ø8.5xø12x7mm Spacer
2C.
Attach Pivot Adjustment Frame
(D)
to Base Frame
(A)
using:
2 - (#2) M10x20mm Button Head Cap Screw
2 - (#8) M10 Flat Washer
2 - (#16) ø25xø18x20mm Bushing
1 - (#22) ø18x132mm Shaft
2D.
Attach Angle Adjustment Frame
(E)
to Top Frame
(F)
using:
2 - (#2) M10x20mm Button Head Cap Screw
2 - (#8) M10 Flat Washer
2 - (#16) ø25xø18x20mm Bushing
1 - (#22) ø18x132mm Shaft
Summary of Contents for SAB500
