14
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 3C. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
3A.
Attach Pivot Arms
(F)
to Pillow Block Bearings
(#14)
using:
4 - (#8) M5x6mm Set Screw
3B.
Attach Weight Horn Frame
(H)
to Pivot Arms
(F)
using:
4 - (#4) M10x70mm Hex Head Bolt
8 - (#10) M10 Flat Washer
4 - (#12) M10 Nylon Lock Nut
3C.
Attach Handle Bar
(J)
to Weight Horn Frame
(H)
using:
4 - (#3) M10x75mm Hex Head Bolt
8 - (#10) M10 Flat Washer
4 - (#12) M10 Nylon Lock Nut
1 - (G) Mounting Bracket
Summary of Contents for Pro Club STBR500
