10
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 1D. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
1A.
Attach Front Center Frame
(A)
to Middle Center Frame
(B)
using:
2 - (#5) M10x25mm Hex Head Bolt
4 - (#10) M10 Flat Washer
2 - (#12) M10 Nylon Lock Nut
1B.
Attach Middle Center Frame
(B)
to Rear Center Frame
(C)
using:
2 - (#2) M10x125mm Hex Head Bolt
4 - (#10) M10 Flat Washer
2 - (#12) M10 Nylon Lock Nut
1 - (L) Steel Plate
1C.
Attach Side Frames
(D)
to Front Center Frame
(A)
using:
4 - (#4) M10x70mm Hex Head Bolt
8 - (#10) M10 Flat Washer
4 - (#12) M10 Nylon Lock Nut
1D.
Attach Foot Plate Frame
(K)
to Side Frames
(D)
using:
4 - (#4) M10x70mm Hex Head Bolt
8 - (#10) M10 Flat Washer
4 - (#12) M10 Nylon Lock Nut
Summary of Contents for Pro Club STBR500
