18
S T E P
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of STEP 4G. Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
4A.
Put the Key Ring of the Lanyard (
#32)
onto the threaded end of the
Selector Rod Top Bolt
(#29)
.
4B.
Install the Selector Rod Top Bolt
(#29)
, Two M12 Hex Nuts
(#27)
onto the Top Plate
(#61)
.
4C.
Route Top Cable
(#38)
and Install four Pulleys
(#38)
as shown in
Step 4 Drawing.
2 - (#4) M10x90mm Hex Head Bolt
2 - (#6) M10x45mm Hex Head Bolt
4 - (#13) M10 Flat Washer
4 - (#17) M10 Nylon Lock Nut
4 - (#39) Spacer
2 - (J) Pulley Bracket
NOTE: Cable (#38) must go over Top Frame (D). Do not put Cable (#38)
through Top Frame (D).
4D.
Install Top Cable
(#38)
by first assembling the small ball end into the Selector
Rod Top Bolt
(#29)
and attaching the Cable Cylinder Lock
(#28)
over
the ball end of the cable. Secure it by tighten in the Set Screw
(#10)
4E.
Install the M10X40mm Hex Head Bolt
(#7)
with two M10 Flat
Washer
(#13)
through the slot hole of the Selector Rod Top Bolt
(#29)
by fastening the M10 Nylon Lock Nut
(#17).
4F.
Route Low Cable
(#24)
and Install three Pulleys
(#26)
as shown in
Step 4 Drawing.
2 - (#5) M10x65mm Hex Head Bolt
1 - (#6) M10x45mm Hex Head Bolt
2 - (#13) M10 Flat Washer
3 - (#17) M10 Nylon Lock Nut
4 - (#25) Spacer
2 - (J) Pulley Bracket
4G.
Attach Low Cable
(#24)
to Center Base Frame
(A)
.
Summary of Contents for GLA400
