Body Solid G6B25YR, Owner'S Manual

Page: 25 / 56

8
Be careful to assemble all components
in the sequence they are presented.
24
S T E P
mm
Inch
A. Attach Right Leg Hold Down (AG) and Left Leg Hold Down (AH) to the Angled Support Frame (D)
using:
Two 56 (3/8” x 3 1/4” hex head bolt)
Four 78 (
M10 washer)
Two 71 (3/8” nylon lock nut)
Slide two 4”x 8” Foam Rollers (18) onto the two Leg Hold Downs (AG) and (AH). Hold in place
with two Plastic Roller End Caps (30).
B. Insert two Nylon Bushings (31) into Back Pad Holder (BA).
Attach Back Pad Holder (BA) to Angled Support Frame (D) using:
Two 53 (3/8” x 3” hex head bolt)
Four 78 (3/8” washer)
Two 71 (3/8” nylon lock nut)
C. Slide two Convex End Caps (3) into the top and bottom of Back Pad Frame (BC).
Attach Back Pad (BB) to Back Pad Frame (BC) using:
Two 60 (5/16” x 1 1/2” hex head bolt)*
Two 77 (5/16” spring lock washer)
Two 76 (5/16” washer)
*Do NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
D. Attach Back Pad Frame (BC) to Back Pad Adjuster (BD) with Pop Pin (65) and using:
One 59
( M10 x 16L allen head bolt
)
One 78 (
M10 washer
)
E. Slide Convex End Cap (2) into the Back Pad Adjuster (BD).
Slide Back Pad Adjuster (BD) into Back Pad Holder (BA) and hold in place with Pop Pin (63) and
using:
One 66 (5/16” x 1/2” flat allen head bolt)
One 76 (5/16” washer)
NOTE:
You should now make sure all bolts and nuts are wrench tight.
Do NOT re-tighten any of the pad bolts.
Also, leave all pulley bolts finger-tight untill after STEP 15.