Body Solid Endurance T25, User Manual

Page: 39 / 48

General Maintenance
39
RUNNING BELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably
level surface. If the frame is not level, the front and back roller cannot run parallel, and
constant belt adjustment may be necessary.
The treadmill is designed to keep the tread-belt reasonably centered while in use. It is
normal for some belts to drift near one side while the belt is running with no one on it. After
a few minutes of use, the tread-belt should have a tendency to center itself. If, during use,
the belt continues to move toward one side, adjustments are necessary.
TO SET RUNNING BELT TRACKING:
7mm Allen wrench is needed to adjust the rear roller. Set belt speed at approximately 2 to
3 mph.
Remember, a small adjustment can make a dramatic difference!
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE WARRANTY.
To move the belt to the Right:
1) Turn the left Roller bolt 1/4 turn
Clockwise (Tighten)
2) Turn the Righ Roller bolt 1/4 turn
Counterclockwise (loosen)
To move the belt to the left:
1) Turn the left Roller bolt 1/4 turn
Counterclockwise (loosen)
2) Turn the Righ Roller bolt 1/4 turn
clockwise (Tighten)
26
·把电动跑步机放在平整的地面上。
·使电动跑步机以大约 3.5 公里 / 小时的速度运行。
·如果跑步带偏向右边，将右边的调节螺栓沿顺时针方向旋转 1/2 圈 或 将左边的调节螺
栓沿逆时针方向旋转 1/2 圈。 如图 A 直至跑步带调节到居中
·如果跑步带偏向左边，将左边的调节螺栓沿顺时针方向旋转 1/2 圈 或 将右边的调节螺
栓沿逆时针方向旋转 1/2 圈。 如图 B 直至跑步带调节到居中
图 A 跑带调向左边 图 B 跑带调向右边
跑步带松紧度：
·若跑步带太松可调节后滚筒螺栓沿顺时针方向旋转（滚筒左右两端调节螺栓需调节相
同圈数）直至跑步带松紧度适宜且处于居中；若跑步带过紧可调节后滚筒螺栓沿逆时
针方向旋转，参照上述步骤直至跑步带松紧度适宜且居中。
26
·把电动跑步机放在平整的地面上。
·使电动跑步机以大约 3.5 公里 / 小时的速度运行。
·如果跑步带偏向右边，将右边的调节螺栓沿顺时针方向旋转 1/2 圈 或 将左边的调节螺
栓沿逆时针方向旋转 1/2 圈。 如图 A 直至跑步带调节到居中
·如果跑步带偏向左边，将左边的调节螺栓沿顺时针方向旋转 1/2 圈 或 将右边的调节螺
栓沿逆时针方向旋转 1/2 圈。 如图 B 直至跑步带调节到居中
图 A 跑带调向左边 图 B 跑带调向右边
跑步带松紧度：
·若跑步带太松可调节后滚筒螺栓沿顺时针方向旋转（滚筒左右两端调节螺栓需调节相
同圈数）直至跑步带松紧度适宜且处于居中；若跑步带过紧可调节后滚筒螺栓沿逆时
针方向旋转，参照上述步骤直至跑步带松紧度适宜且居中。