Hardware Required
Assembly Step 6
A.) Height Adjustment Tube Assembly
With the help of an assistant, attach the
Height Adjustment Tube
(#04)
to the
Base of Height Adjustment Tube (#10)
by pulling the
Height Selector Lock Pin (#32)
out and simultaneously sliding the
Height Adjustment Tube (#04)
in
. Release the
Height Selector
Lock Pin (#32)
at any setting for now. Please note, the
Height
Adjustment Tube (#04)
is designed to accommodate the height of
various persons; set it accordingly by pulling the
Height Selector
Lock Pin (#32)
as you slide the
Height Adjustment Tube (#04)
up
or down. Hook on the
Safety Strap with Buckle (#16)
that is located
on the A-Frame to the
U Shape Frame (#52)
.
B.) Safety Bar Assembly
Slide the
Safety Bar (#14)
into the hole on the
Rear Support Tube
(#01)
, secure it with a
Quick Clip (#
51
)
. The assembly process is
now complete. Please read the rest of the manual to learn about the
safety features and operation procedures before you start using the
product.
NOTE: To control the angle of inversion, adjust the
Safety Strap
with Buckle (#16)
according to the Usage Guidelines starting from
page 11. For an additional safety measure, use the
Safety Bar (#14)
as an additional safety support in case the safety strap is not adjusted
properly. This is highly recommended for beginners. For advance
users that wish to perform a 180 degree inversion, you must remove
the
Safety Bar (#14)
in order to perform the 180 degree inversion.
Others
#51. Quick Clip
[1 Piece]
B
A
Assembly Instructions
IT9910
Page
10
