Body Go SPINNING BIKE, Owner'S Manual, Page: 7 / 8

- 6 -
Step C:
Insert the Saddle (8) into the Saddle slider (5)
and then fasten with tools.
Insert the Saddle slider (5) in to the Saddle
post (4) and then fix with Pop-pin knob (9) at a
suitable position.
Insert the Saddle post (4) to the Main frame (1)
to an appropriate height, fixing with the
Pop-pin knob (9)
Note: You can just loosen couple thread and
pull the knob instead of turning out knob (9)
when you need to adjust the position of the
saddle.
Make sure the Saddle (8) is tightened to the
Saddle slider (5) before getting on the Bike.
Step D:
Attach the Handlebar (24) and Meter bracket
(31) to the Handlebar post (6) using the Allen
bolts (18), Spring washers (19) and Flat
washers (27);
Attach the Handlebar lower shield (26) to the
Handlebar post (6) and then fix the Handlebar
lower shield (26) and Handlebar upper shield
(25) with Cross tapping screws (20);
Fix the Handlebar post (6) to the front post of
Main frame (1) with the Pop-pin knob (9);
Fix the Bottle cage (11) on the Main frame (1)
with Cross tapping screw (16) and Flat washer
(17), and then insert the Bottle (12) to the
Bottle cage (11) as shown;
Insert the Meter (30) onto the Meter bracket (31), and then insert the Sensor wire (32) into
the hole on the back of Meter (30).
Note
FULLY TIGHTEN all Bolts, Nuts and Fittings now, ensuring that your product in located on
a clear flat surface before doing so.
Your product will now be ready to use.