A s s e m b l y S t e p 5
Hardware & Tool Required
Washer
Nut
#84 W
asher (φ10.5x2xφ20)
[1 Piece]
Others
#17 Knob Bolt (M8x36 mm)
[1 Piece]
Tools
#70
T
ool 3 (S13-14-15)
#81
W
asher (φ8.2x1.2xφ17)
[3 Pieces]
#82 Nylon Nut (M8)
[3 Pieces]
#57 Knob Bolt (
M12x
24 mm)
[1 Piece]
#42 WASHER FOR M10 BOLT,T2.0 1PC
#42 WASHER FOR M10 BOLT,T2.0 1PC
#42 WASHER FOR M10 BOLT,T2.0 1PC
Assembly Instructions
BRD 3700/2800
Page 10
101
Remove
Washers (#81)
and
Nylon Nuts (#82)
that are
pre-assembled on the back of the
Seat (#79)
and set them
aside as they will be used in a later process.
Attach the
Seat (#79)
to the
Horizontal Seat Bar (#80)
using a total of three
Washers (#81)
and three
Nylon Nuts
(#82).
Attach the
Horizontal Seat Bar (#80)
to the
Seat Post
(#83)
. Insert a
Knob Bolt (#17)
through a
Washer (#84)
,
followed by the
Seat Post (#83)
and
Horizontal Seat
Bar (#80),
secure them together by tightening the
Knob
Bolt (#17)
into the bottom of the
Horizontal Seat Bar
(#80)
.
Remove
Knob Bolt (#57)
that are pre-assembled on the
Main Frame (#101)
and set them aside as they will be used
in a later process.
Insert the
Seat Post (#83)
a minimum of 4 inches into the
Main Frame (#101)
to engage the lowest hole and secure by
screwing in the
Knob Bolt (#57)
. Please ensure that the hole
on the
Seat Post (#83)
is facing the same side as the
Knob
Bolt (#57)
so it can be aligned and fully engage through the
lowest corresponding hole on the
Main Frame (#101).
You may adjust the
Seat Post (#83)
to the height most comfortable for you
after complete assembly. Please always
check to ensure a hole has been fully
engaged when you secure and tighten
the
Knob Bolt (#57)
.
