Assembly Instructions
PT817 / PT890
A.) Align and attach the
Rear Base (#04)
to the
Left Base Tube
(#09)
as illustrated in the diagram. Insert two
Hex Bolts (#19)
through the the
Rear Base (#04)
followed by the
Left Base Tube
(#09)
, secure them together using two
Washers (#21)
and two
Nylon Nuts (#23)
.
Page 6
NOTE:
B.) With the help of an assistant, align and attach the
Left Upright
(#02)
to the
Left Base Tube (#09).
Next, align and attach the
Front
Base (#03)
to the
Left Base Tube (#09)
and as illustrated in the
diagram. Insert two
Hex Bolts (#20)
through the
Front Base
(#03)
followed by the
Left Upright (#02)
and
Left Base Tube (#09)
,
secure them together using two
Nylon Nuts (#23)
.
Repeat this process on the other side.
Assembly Step 1
Hardware Required
#21. Washer (M10)
[4 pieces]
Nut
BOLT
#19. Hex Bolt (M10x70 mm)
[4 pieces]
#20. Hex Bolt (M10x75 mm)
[4 pieces]
Washer
#23. Nylon Nut (M10)
[8 pieces]
To avoid misalignment due to over-tightening, please do not use a wrench at this time.
Hand-tightening for now will help ensure easy assembly. Wrench-tightening should
be performed after all parts are assembled to ensure all nuts, bolts, and parts are tightly secured before use.
B
A
LEFT
RIGHT
FRONT
REAR
*
*
*
Drawings are rotated 180 degrees
for maximum clarity in the assembly
process. Hence, “left” and “right”
sides may appear to be reversed.
