Body Charger GT8600RF, Owner'S Manual

Page: 25 / 32

MAINTENANCE AND TECHNICAL DATA
Malfunction Problem Probable Cause Countermeasure
Running Belt
tracking not in
center
Noise coming out when
treadmill is running
Display maybe reduced
brighten and flash
HR readout is not show
erratic
Floor not level
Probable the obstruction stuck into the
Running Belt
Running is not tracking in center, to right or
left to touch the side.
Hardware as screw is not installed properly
Damaged Console PCB
Damaged Safety Key Sensor
Hands hold Hand Contact Sensors not
properly position
Damaged HR PCB
Damaged or connected improperly Control
Message wire
Belt Transmitter is not wet enough to
catch accurate heart rate
Belt Transmitter is not wearing properly
and not perfectly fit the skin.
Belt Transmitter needs to clean
Belt Transmitter is far away of heart rate
receiver
Belt Transmitter is at low Battery
Check rest legs and adjust it to be sure the treadmill is leveled see instructions 2.1as shown
how to adjust. Adjust the Running Belt tracking in Center see instructions 2.8 as shown how
to adjust.
Check and remove all possible obstructions and tinsel to interfere the Running Belt.
Check rest legs and adjust it to be sure the treadmill is leveled see instructions 2.1as
shown how to adjust. Adjust the Running Belt tracking in Center see instructions 2.8 as
shown how to adjust.
Checking hardware, all screws and accessories and position it again properly.
Contact the Technician Services or replaced by the Qualified Technician.
Contact the Technician Services or replaced by the Qualified Technician.
Make sure hands have to hold Hand Contact Sensors in properly position when measuring.
Contact the Technician Services or replaced by the Qualified Technician.
Reconnect properly control message wire or Contact the Technician Services or replaced by
the Qualified Technician.
Wet the Belt Transmitter electrodes see instructions 4.14.14.
Make sure the Belt Transmitter wearing on properly see instructions 4.14.14 as shown.
Clean the Belt Transmitter with soft cleaner and water.
Keep the Belt Transmitter within 80cm(2.6 feet) to catch the receiver.
Replace Battery. Contact the Service Technician Services or replaced by the Qualified Technician.
24