BRB 5007
#26. Screw (M8x15 mm)
[3 pieces]
#24. Screw (M8x80 mm)
[2 pieces]
Washer
#51. Screw (M8x35 mm)
[1 piece]
#34. Washer (M8)
[4 pieces]
#32. Arc Washer (M8)
[3 pieces]
#33. Spring Washer (M8)
[3 pieces]
SENSOR WIRE ASSEMBLY
TENSION WIRE ASSEMBLY
Insert the tip of the
Tension Controller(#19)
wire into the
Tension
Controller Cable (#36)
head at an angle. Tilt the
Tension Controller
(#19)
wire into the crevice and then pull upward.
Bolt
Nut
#31. Nut (M8)
[2 pieces]
H a r d w a r e R e q u i r e d
A.) Cushion Frame Assembly
Attach the
Cushion Frame (#
05)
by sliding it into the bracket on the
Rear Base
(#02)
. With the help of an assistant holding the
Cushion Frame (#
05)
, attach
the
Left Handle Bar (#08)
and
Right Handle Bar (#09)
to the outer sides of the
same bracket on the
Rear Base (#02)
. Secure the
Cushion Frame (#
05), Left
Handle Bar (#08)
, and
Right Handle Bar (#09)
by inserting two
Screws (#24)
through two
Washers (#34)
(through the
Left Handle Bar (#08), Rear Base
(#02)
, and
Cushion Frame (#
05)
) followed by two
Washers (#34)
and two
Nylon
Nuts (#31)
from the
Right Handle Bar (#09)
. Then Secure the
Screw (#51)
Next, connect Sensor
Wire 5 (#42)
to
Handle Pulse (#44)
as shown in the
corresponding diagram below.
B.) Front Post Assembly
With the help of an assistant to hold the
Front Post (#06)
, connect
Sensor Wire
1 (#38)
to
Sensor Wire 2 (#39)
; and
Sensor Wire 3 (#40)
to
Sensor Wire 4 (#41)
.
Also, assemble the tension wire by inserting the
Tension Controller (#19)
into
the
Tension Controller Cable (#36)
as detailed and described below. Slide the
Front Post (#06)
onto the
Main Frame (#01)
making sure all wires are tucked
and won’t get pinched. Then, secure it using three
Screws (#26)
, three
Spring
Washers (#33)
, and three
Arc Washers (#32)
that were previously removed.
Remove the three
Screws (#26)
, three
Spring Washers (#33)
and three
Arc
Washers (#32)
that are pre-assembled on the
Main Frame (#01)
and set them aside.
A s s e m b l y S t e p 2
Page 6
A
B
19
19
19
36
36
36
directly into the
Cushion Frame (#
05)
. Please refer to the illustration below for
proper assembly pattern.
Assembly Instructions
