FRONT BUMPER
2015-16 FORD F150
Page 2 of 5
2/23/16 (DP)
8.
Level and adjust the bumper and fully tighten all hardware.
9.
On models with bolt on frame extensions, remove the extensions from outside of frame,
(Figure 9)
.
10.
If front license plate is required, attach the License Plate Bracket to the holes in the bumper with the
included (2) 6mm x 20mm Button Head Screws, (4) 6mm Flat Washers and (2) 6mm Nylon Lock Nuts.
Insert (2) Plastic Plugs into the square holes in the Bracket. Reuse the factory screws to attach the
license plate to the plastic plugs,
(Figure 10)
.
11.
On Ecoboost models, remove the (2) flat covers from the bottom of the bumper,
(Figure 11)
.
12. Center LED light installation
as supplied with bumper or sold separately.
a.
Select the L/R “L” Brackets,
(Figure 12)
. Attach the Brackets to the top of the (2) mounting tabs
welded onto the back of the bumper with the included 8mm x 25mm Hex Bolts, (4) 8mm Flat
Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts. Leave loose at this time.
b.
Attach the LED light assembly to the “L” Brackets with the included (2) 8mm x 16mm Hex Bolts,
(2) 8mm Lock Washers and (2) 8mm Flat Washers. Do not fully tighten hardware at this time.
IMPORTANT
: “L” Brackets are designed for 8mm light mounting hardware only. Modify “L”
Brackets if necessary or use brackets supplied by your light manufacturer if possible to install
hardware larger than 8mm.
c.
Follow light manufacturer’s instructions to properly wire the light.
13. LED light installation at ends of bumper
as supplied with bumper or sold separately.
a.
Insert light into opening and up to mounting slots. Check for clearance between front and back
of light. If necessary, remove the screen from the back of the opening,
(Figure 13)
.
b.
Follow the light manufacturer’s instructions to attach (1) light to the center slot or (2) lights to the
inner and outer slots in the top of the light opening,
(Figure 14)
.
IMPORTANT
: On two light
systems, attach the flood light to the outer slot and the spot light to the inner slot.
c.
Repeat the above steps for passenger side light installation.
d.
Follow light manufacturer’s instructions to properly wire the light.
14.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish. Mild soap may be used to clean the Bumper assembly.
Driver Side Installation Pictured
(Fig 1) Remove spoiler and pads from bumper
(Fig 2) Remove license plate. From behind
bumper, release metal clips attaching
plastic bumper pad to the bumper
Front