11
Section Three: Physical Installation
Installation of the SuperX VGA board is simple and quick for the
expert and novice alike. The following instructions assume an
AT-style or compatible machine. Obviously, locations and types
of screws as well as type of case cover will vary based on your
particular system. Refer to your computer system documentation
for additional assistance.
1. Turn the power switch to the OFF position.
2. Remove the power cord from the back of the computer.
3. Unplug the keyboard cable found in the lower middle of the
computer’s rear panel.
4. Use a small screwdriver to remove the screws that attach the
computer’s cover to the rear panel.
5. Carefully slide the cover forward—away from the rear panel.
Be careful not to let the cover catch on internal cables to the
disk drive and power supply.
The SuperX VGA board must be installed in any
available 16-bit slot in your system. Adapter card
connector slots normally reside in the rear of the system
board adjacent to the power supply. There are usually
anywhere from five to eight edge connectors, depending
on the model of your system.
Physical Installation
Summary of Contents for SuperX SVGA25
Page 2: ...2 SuperX VGA by BOCA...
Page 42: ...42 SuperX VGA by BOCA...
Page 43: ...43...
Page 44: ...44 SuperX VGA by BOCA Manual Part 9473 Rev 1 1...