14
BOCALANcard-PCI
7. Replace the system cover and secure it with the screws
you removed in step 2.
Connecting Cables
8. Connect cables.
a. If attaching to an unshielded twisted-pair network,
connect one end of the 10base-T cable to the RJ-45
connector on the board. Attach the remaining end to a
network outlet, hub, or concentrator as shown below:
b. If attaching to “thin coax” cable:
1. Attach a BNC T-Connector to the BNC port on the
board. Align the notches on the card’s BNC connector
with those on the T-Connector. Twist clockwise
approximately one-quarter turn.
2. Is the workstation at the end of the cable segment?
RJ-45
Connector
RJ-45
Cable
Wall
Jack
Hub or
Concentrator
123456789
123456789
Punch-
down
Block
Boca’s Ethernet products
use standard pinouts. Refer
to Appendix E for pin
assignments.
