27
Tying the knots (Uni-knot)
This knot is called the Uni-knot and has "how to" videos on
You-Tube.
1. Loop the string through the locking block of the nylon tie.
2. Loop the same string behind the horizontal stationary string,
bring it up over both horizontal strings
3. Repeat step 2 for a total of 5 loops.
4. pull the knot tag end and tighten the knot.
The tied length of the string from one nylon tie to the other is:
X-string
L = 330 - 350 mm
Y-string
L = 690 - 710 mm
X string Drive
1. Place a large nylon tie into behind the string holder, then thread the large tie connected
to the string through the string holder into the loose nylon tie
2. Push the bed to the rear stop making the coupler closer to the nylon tie.
3. Push the nylon tie connected to the sting into the string holder until the nylon tie is no
longer touching the threaded coupler
Summary of Contents for RP8
Page 1: ...RP9 Assembly Instructions ...
