Form No. DR-5750
68-10216 rev01
(Rev. 10/7/13) © 2013 Gamco Commercial Restroom Accessories, A Division of Bobrick Printed in U.S.A.
2
DANGER
DANGER
WARNING
CAUTION
Gamco recess mounted, ADA compliant warm air hand dryer, powered by a high speed universal motor, delivering 2300 Watts of drying
power. This hand dryer runs on 115 Volts AC, 208/220-240 Volts AC, or 277 volts AC electrical supply, depending on model. Automatic
and push-button models are represented in this product group. This appliance is intended for use in hand drying, contributing to hygienic
and cost effective hand sanitation. This hand dryer may be used in commercial, industrial, office and public facility environments.
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose, missing or damaged parts. If the hand
dryer is damaged, promptly inform the shipper or dealer where you purchased it.
Failure to disconnect the power source before installation or servicing can result in
serious injury or death from electric shock.
• Always disconnect the power source before servicing or installing the hand dryer.
Failure to properly ground this unit could result in severe electrical shock and/or
death.
• This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground connection point is supplied on the
hand dryer’s wall base.
• We recommend GFCI protection in wet or damp locations or as required by local code.
Risk of fire, personal injury or property damage are possible if local codes, NEC
codes or safety recommendations are not followed.
• Use only the electrical power (voltage and frequency) specified for the model hand dryer being installed.
• Connect the hand dryer to the nearest suitable distribution panel.
• To limit a voltage drop, and insure efficient operation, use wire gauge as required by local or National Electrical Code.
• Do not connect to a branch circuit with CB or fuse protection over 20 Amps. This is in compliance with The National Electrical Code
#210-20.
• All automatic model hand dryers must have a dedicated 20 Amp circuit as required by Underwriters Laboratories, Inc. (UL).
• Route all field wiring away from any moving parts within the hand dryer.
Improper mounting could result in personal injury or property damage.
(cULus Listed, E43125, CE TUV-GS)
Description
General Specifications
Electrical Specifications
General Safety Information
Unpacking
Basic Models
Nozzle
Drying Cycle
Dimensions (WxDxH)
Weight
Cover Material
DR-5750
Fixed
Automatic
13.1" x 13.8" x 4"
333 mm x 351 mm x 102 mm
35 lbs / 15.9 kgs
Cast Iron
Models
Type
Electrical Input
Amperage
Watts
DR-5750
Automatic
115 VAC, 60 Hz
20
2300
