10
11
Daily cleaning and
maintenance
BOBOT ROBOTICS INC.
Simple faults and
handling methods
BOBOT ROBOTICS INC.
7. imple faults and handling methods
6.5 Disassembly and replacement of battery pack
6.4 Removal of foreign matter blockage
When the air duct is blocked, the indicator will light up, then the machine switches
into low gear mode. Meanwhile, please turn down the power, and check the air
duct, remove the blockage, and then use it again.
Remove the foreign matter blocked by the floor brush: refer to "cleaning the
roller brush".
Remove the foreign matter blocking the extension tube, dissemble the
extension tube, check and dredge it, and then replace it.
1.Turn off the power, press the release button at the bottom of the battery pack, and
take out the battery pack.
2.Align the new battery pack with the battery card slot of the hand-held vacuum
cleaner, then insert it and snap it in place.
1. Turn off the power and remove the electric floor brush;
2. Press the roll brush release button, the side roll brush cover plate will pop open
and unlock;
3. Turn the roller cover clockwise and pull out the roller together;
4. Remove the winding and garbage on the roller;
5. Push one end of the clean (or brand-new) roller connecting the shaft into the
electric floor brush first, and then press the cover plate of the roller brush
，
turn
clockwise and lock.
Note:
This vacuum cleaner must use the original battery pack and power adapter.
Do not use the battery pack for any purpose other than this vacuum cleaner.
Fault
phenomenon
Possible causes Processing method
Vacuum cleaner
fails to start
Refer to the manual "battery
charging" for correct charging
Dust collecting cup full
Dust collecting cup or
separation filter not
installed correctly
Dust collecting cup or
separation filter not
installed correctly
The roller brush is twisted
or stuck, and the protection
device is started
The vacuum
cleaner has no
or small suction
There is obvious
dust leakage from
the vacuum cleaner
The rolling brush
stops rotating
Shorter use time
after charging
Empty dust
Refer to the manual "removal of
foreign matter blockage"
Reinstall the dust collection cup
or separation filter correctly
Empty the garbage in the dust
collecting cup
Reinstall the dust collection cup
or separation filter correctly
Refer to the manual "removal of
foreign matter blockage"
Refer to the manual "battery
charging" for correct charging
Replace the original battery
pack after purchase
Dust collecting cup full
The extension tube or floor
brush is blocked by foreign
matters
Low battery
Insufficient charging time
Battery aging
W a r n i n g : i n c a s e o f a b n o r m a l o p e r a t i o n o f t h e
v a c u u m c l e a n e r , p l e a s e t u r n o f f t h e v a c u u m
Warning: If the above prompt still cannot solve the machine problem,
please contact our after-sales service or technical personnel Contact, do
not disassemble and repair by yourself!
