INSTALLATION FOR THE ROLLER BRUSH COVER
Insert the roller brush cover into the corresponding position at the floor brush as shown in
Fig.12. There is a fastener at the roller brush cover, and the roller brush cover is installed
well in position after you hearing a sound of "click" (see Fig.13) .
Fig.12
Fig.13
OPERATION
CHARGE THE APPLIANCE
1. Insert the adapter of charger into the power outlet (see Fig.14).
2. Put the appliance onto the charger, and the battery indicator turns on and the appliance
enters into the charging condition. And the charging is finished after the battery indicator
turns off (see Fig.15).
3. After finish charging, unplug the adapter.
Fig.14
Fig.15
OPERATING THE APPLIANCE
Before using the appliance, make sure the appliance is charged well.
1. Remove the appliance from the charger and adjust the appliance to the normal working
condition from the upright position.
NOTE:
The appliance can not work when it is placed upright.
2. Press the
Power button
, the indicators and the light ring on the control panel illuminate
for a while, then only the
Battery indicator
illuminates, and the appliance starts to work
and there is water spraying out from the appliance. If you want to activate the UV
sterilization function, press the
UV button,
then the
UV indicator
turns on.
3. If you want to increase the water amount, press the
Water button
, and more water will
be sprayed out from the appliance, and then you can clean the place where needs more
water for cleaning.
4. The
Refill indicator
will blink in red if the clean water tank is lack of water, please
refill the clean water tank with pure water in time.
5. The
Full indicator
will blink in red if the dirty water tank is full, please empty the dirty
water tank in time.
9
10
OPERATION
OPERATION