12
CAUTION:
READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON
YOUR MARKER. SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK
PROFESSIONAL SUPPORT.
Cleaning the Poppet and Reassembly
Once all the parts are disassembled and cleaned, the poppet can be lubricated then the marker
reassembled.
1.
Clean debris and excess grease from the
poppet surface then inspect and grease the
poppet o-ring. Replace the o-ring if any
nicks or deformations are visible.
2.
Slide the poppet back into the rear of the
body.
3.
Inspect the four air passage holes to ensure
the o-rings are in place and undamaged.
Lightly lubricate these if no grease is visible.
4.
Place the poppet return spring into the main
body front. The larger portion of the spring
goes towards the front.
5.
Tilt the rear of the main body rear up slightly
and slide the two halves together. Make sure
the poppet return spring remains seated in
the main body front while the small
diameter portion slides over the poppet.
6.
Slide the body halves fully together. The tab
at the bottom of the main body front will
slide into the main body rear. Make sure the
top of the tab is against the top of the
opening in the main body rear.
7.
To verify correct alignment take a look at the
feedneck area. If they are even, things look
good. Place the feedneck in position and
continue with reassembly.
8.
Insert and tighten the left and right front
facing body screws
9.
Tighten the lower feedneck screw
10.
Insert and tighten the front grip frame screw
11.
Tighten the rear grip frame screw.
12.
Install the eye retaining screws, detents, eye
covers, ram, back cap, bolt, ham sandwich,
and any other parts you removed during
disassembly. If you have extra parts when
you get finished you have a problem.
3
5
6
7
